@jzatopa: I'am not using my steppers for printers. I´ve build a pan/tilt-head, which can move my camera. Going to 24V is not possible, since it is a portable setup which runs on 12V-batteries.
I was able to generate following graphs, which show you the moved distance of each step:
NEMA 14 stepper from Pololu at full-steps (constant steps, as it is necessary for my application):
[attachment 29992 KleinFULL.JPG]
NEMA 14 stepper from Pololu at 1/8-steps:
[attachment 29994 kleinDelay.JPG]
NEMA 17 from Trinamic which is descripted as "optimised for microstepping" at 1/8-steps:
[attachment 29993 grossDelay.JPG]
I was able to generate following graphs, which show you the moved distance of each step:
NEMA 14 stepper from Pololu at full-steps (constant steps, as it is necessary for my application):
[attachment 29992 KleinFULL.JPG]
NEMA 14 stepper from Pololu at 1/8-steps:
[attachment 29994 kleinDelay.JPG]
NEMA 17 from Trinamic which is descripted as "optimised for microstepping" at 1/8-steps:
[attachment 29993 grossDelay.JPG]