If you mean ramps 1.4 all you need to do is get the drivers the right way around, check carefully if they're the wrong way and you power it up it will fry your ramps and arduino and probably the lv driver too. Make sure power and USB power is disconnected when inserting or removing drivers.
Get the jumpers under the drivers right for the microstepping you want. Less danger here as there is no jumper configuration which will damage anything if you get them wrong.
Once installed home and move 100mm if it moves 100mm then it's correct if not the jumpers are wrong. The jumper config is in the documents I linked to in the original post.
Get the jumpers under the drivers right for the microstepping you want. Less danger here as there is no jumper configuration which will damage anything if you get them wrong.
Once installed home and move 100mm if it moves 100mm then it's correct if not the jumpers are wrong. The jumper config is in the documents I linked to in the original post.