I am pre thinking how I am going to setup a hypercube evolution build I hope to make happen soon.
I want dual Z drive, I am likely to use an MKS Gen 1.4 board like I have in my baby cube I use now.
I have TMC2100 stepsticks and love them!! But they have pretty low current capacity...
IF I run dual Z motors in parallel on one step stick I think I am unlikely to have the power I need....
Suggestions?
Oh I plan two extruders so I cant use dual drivers on this setup.....
Maybe I should look at a Rumba so I can run six step sticks....
What other decent boards are there with six step sticks... Seems like there is always something I don't like on every one I look at....
I want dual Z drive, I am likely to use an MKS Gen 1.4 board like I have in my baby cube I use now.
I have TMC2100 stepsticks and love them!! But they have pretty low current capacity...
IF I run dual Z motors in parallel on one step stick I think I am unlikely to have the power I need....
Suggestions?
Oh I plan two extruders so I cant use dual drivers on this setup.....
Maybe I should look at a Rumba so I can run six step sticks....
What other decent boards are there with six step sticks... Seems like there is always something I don't like on every one I look at....