But even if I use microsteps, I'll not "gain" strenght as well in motors, so I Suposed that they should work in same condicions with no microsteping, right?when I use microsteping, the feed rate is the same, or like, if I use a 16 microstep in drv8825, to insert feedrate, as maximum I can get with no microsteps is 5mm/s, i could do something like 5*16=80mm/s or this owrks automatically?I think there's something wrong about z axis, cause I can change to any high value in feedrate as aceleration, it still works like 5mm/s, even if I adjust all others axis feedrates and aceleration.
↧