I don't even know what to believe anymore about these drivers.Some users say they have the clones working with jumping the CFG-1 to GND, no mention of the solder pad on the bottom. others say remove the CFG2 pin from the header completely, in conjunction with removing the jumpers from the MKS Gen1.4 boards (RAMPS based). others say not to? How do you even know if they're in spreadCycle mode? How does one check?
even the reprap wiki is short on information regarding the CFG2 pin removal.
not sure if I even want to bother dicking around with these things because of those stupid solder pads. why anyone would expect a customer to successfully solder those with ease with pin headers in the way is beyond me, but whatever.
buy the watterott versions, they're documented better and don't require microscoping soldering
even the reprap wiki is short on information regarding the CFG2 pin removal.
not sure if I even want to bother dicking around with these things because of those stupid solder pads. why anyone would expect a customer to successfully solder those with ease with pin headers in the way is beyond me, but whatever.
buy the watterott versions, they're documented better and don't require microscoping soldering