wellllll... i wouldn't bother buying the MKS version of these stepper drivers.
with the smallest tip available from Weller and a decent soldering iron, good solder, and a 600x microscope, modifying the CFG1 jumper on the bottom is a crap-shoot at best.
I jumped 2 of the 4 I ordered, so to me, these are too risky to be worth it.
Is there any other way I can jump these two pins? The solder pads are no longer on the board. Where else can I jump them?
with the smallest tip available from Weller and a decent soldering iron, good solder, and a 600x microscope, modifying the CFG1 jumper on the bottom is a crap-shoot at best.
I jumped 2 of the 4 I ordered, so to me, these are too risky to be worth it.
Is there any other way I can jump these two pins? The solder pads are no longer on the board. Where else can I jump them?