hcker2000 Wrote:
-------------------------------------------------------
> Can any one weigh in on if these are strong enough
> for a prusa i3?
They should be fine for the X, Y and Z axis, I wouldn't use them in an extruder though.
> Also will they work with the ramps
> board just fine? If so I will buy some.
They should work with ramps just fine.
-------------------------------------------------------
> Can any one weigh in on if these are strong enough
> for a prusa i3?
They should be fine for the X, Y and Z axis, I wouldn't use them in an extruder though.
> Also will they work with the ramps
> board just fine? If so I will buy some.
They should work with ramps just fine.