You cant easily use a MKS Base v1.1 controller board. It already has stepper drivers on it, and it doesn't break out the step,direct or enabled lines for each stepper driver.
The only way you can use this is if your really good at soldering and can solder onto the stepper driver pins. (or the 2560 cpu pins)
Another option is you could update the firmware pins definitions and move the steppers control pins to the expansion ports. (can't have a lcd as well)
Ether way this is a "crappy" job
The only way you can use this is if your really good at soldering and can solder onto the stepper driver pins. (or the 2560 cpu pins)
Another option is you could update the firmware pins definitions and move the steppers control pins to the expansion ports. (can't have a lcd as well)
Ether way this is a "crappy" job