Tks for all your comments.
For the door, the magnetic switch is OK, when I open the door, the display prints "door open" !!!
And about latch, I've already check the solenoid (26 ohm and the pin goes out with 12V). It is more probably the command ... (what is the tension at the pins of its transistor ?)
So I will try your advice about the dip on the 186 board ( not the largest ? PCD is the largest on my model, 186 is on the upper right corner ?).
How do you know this kind of "cheat" mode ? (is it possible to have these informations ?) please 8-)
PS what is your machine number (by private MP ?)
For the door, the magnetic switch is OK, when I open the door, the display prints "door open" !!!
And about latch, I've already check the solenoid (26 ohm and the pin goes out with 12V). It is more probably the command ... (what is the tension at the pins of its transistor ?)
So I will try your advice about the dip on the 186 board ( not the largest ? PCD is the largest on my model, 186 is on the upper right corner ?).
How do you know this kind of "cheat" mode ? (is it possible to have these informations ?) please 8-)
PS what is your machine number (by private MP ?)