Quote
nike357
Thanks, any suggestions on the wirering? It has a 6pin connector but only four have been used with the original cables.
Use those four connections. To work out which pairs of wires are a phase, short two of them together. If that makes rthe spindle harder to turn, that pair of wires are one phase and the other pair is the other phase.
Quote
nike357
Concerning 24Volt electronics, what might be an option? I only have worked on the Ramps/Arduino Mega.
I suggest Duet, Smoothieboard, or one of the Smoothie clones. These are all 32-bit boards. There are a few 8-bit boards that are 24V-capable too, but I don't think they cost any less than 32-bit boards.