I have 24v input into Mainboard already, but Not 100% sure how the driver work.
first, my board only have one output for z axis,
if using your way, which mean connect all 4 stepper motor in serie, then it will yes keep the current all same, but spread voltage among all motors, am I correct?
, I know my Mainboard build with A4988 driver,
so does the driver would automatically regulate voltage if connected in serier, or regulate current if connected in parallel?
if both answer is yes, the solution is already there,
but if no, I still need to return my original question that I need to find other device to balance current/voltage for more demand of extra motors.
first, my board only have one output for z axis,
if using your way, which mean connect all 4 stepper motor in serie, then it will yes keep the current all same, but spread voltage among all motors, am I correct?
, I know my Mainboard build with A4988 driver,
so does the driver would automatically regulate voltage if connected in serier, or regulate current if connected in parallel?
if both answer is yes, the solution is already there,
but if no, I still need to return my original question that I need to find other device to balance current/voltage for more demand of extra motors.