I have this 6 lead Stepper motor 6 volts 0.6 amp.
![jAB1Uz2.jpg]( "jAB1Uz2.jpg")
this is the lead pic
![PSguz5m.jpg]( "PSguz5m.jpg")
can i use this for the RAMPS 1.4 board? I know that usual motors are 4 leads. but is there any way for me to use this?
this is the lead pic
can i use this for the RAMPS 1.4 board? I know that usual motors are 4 leads. but is there any way for me to use this?