I just got my ramps board figured out but I can't get the stepper motors to move. I have only 1 plugged in for now and I send commands using repetier and it doesn't move. Repetier also reports strange steps using the manual controls.
I have:
Arduino 2560
Ramps 1.4
DRV8825 drivers
FIGURED OUT!
New problem:
The stepper only moves about 1/10th of what it is supposed to. Anyone know how to change movement distance? I'm using repetier as it is the only one that would work with my drv8825's.
I have:
Arduino 2560
Ramps 1.4
DRV8825 drivers
FIGURED OUT!
New problem:
The stepper only moves about 1/10th of what it is supposed to. Anyone know how to change movement distance? I'm using repetier as it is the only one that would work with my drv8825's.