Just throwing it out there that your name and post title make me weary of replying
Make sure you have the proper steps per mm set in your firmware, and make sure you're taking into account your microstepping.
Based on the normal spec, you have 16 tooth, GT2 pulleys? Standard motors with 1/16th stepping set on drivers will run you 100 steps/mm.
Make sure you have the proper steps per mm set in your firmware, and make sure you're taking into account your microstepping.
Based on the normal spec, you have 16 tooth, GT2 pulleys? Standard motors with 1/16th stepping set on drivers will run you 100 steps/mm.