Quote
tyscof
Ok so If I set my #define _AXIS_STEP_PER_UNIT higher like to 100 the smaller step like.1 works fine but when I try to hit 1 it just makes a high pitch noise and doesn't move. I set it to 100 because when I set it to 50 it took two hit of .1 to get it to jog once, but say if I try to jog 100 the y doesn't move it just makes a loud high pitch noise, know any cause of this? Likewise if I set it lower it can do the larger jogs but I have to hit the .1 jog like 50 times to get it to move anywhere.
Turn axis acceleration and speed down very low, you can raise them up later.