OK so we have movement! I change this value which I think is what I was supposed to,
it was this #define _AXIS_STEP_PER_UNIT {80, 80, 3200/1.25,700 and
I changed it to this }#define _AXIS_STEP_PER_UNIT {10, 80, 3200/1.25,700}
I went on a online calculator and it said to make it 80 [calculator.josefprusa.cz] but I found the lower I set it it would move so I just set it to 10 and found that it started moving, the question is what value I will need to set it at since the calculation doesn't seem to work(ill try again) I tried it at 53.3 and It wouldn't move either till it got down to around high 20's. A problem I have now is that If I jog right it will go right then hit a point and jog back left even though I hit jog right and then will keep going back and forth. Is this because it is not homed yet? Nd how do I set home? I don't see it anywhere.
it was this #define _AXIS_STEP_PER_UNIT {80, 80, 3200/1.25,700 and
I changed it to this }#define _AXIS_STEP_PER_UNIT {10, 80, 3200/1.25,700}
I went on a online calculator and it said to make it 80 [calculator.josefprusa.cz] but I found the lower I set it it would move so I just set it to 10 and found that it started moving, the question is what value I will need to set it at since the calculation doesn't seem to work(ill try again) I tried it at 53.3 and It wouldn't move either till it got down to around high 20's. A problem I have now is that If I jog right it will go right then hit a point and jog back left even though I hit jog right and then will keep going back and forth. Is this because it is not homed yet? Nd how do I set home? I don't see it anywhere.