Quantcast
Channel: Reprap Forum - Stepper Motors, Servo Motors, DC Motors
Viewing all articles
Browse latest Browse all 2228

Re: Motors wont turn same old same old

$
0
0
Okay so then I do have my motors wired correctly, I have them as pins order 1,3,4,6. I have the two wires for a coil on one side and two wires for the other coil on the other side. I checked the voltage the motor was getting to make sure and when I put my meter over the two leftmost wires(B+ and B- or wires 1 and 3) and got a voltage of 12.8 and the same when I put it over the other two wires. So could this be a problem with my drivers or board? I don't think it could be my drivers because none of them work but I don't know if that really means anything. I guess we could safely assume the motors are getting enough amperage and that wouldn't be the problem, unless the shaft not moving may indicate that, but it isn't turn able when there is a current on it. It also can't be the motors since all 5 do not work, would the endstops be causing this? I just unplugged them since they were in the way but that shouldn't matter if I'm just jogging the motors right? It should't make a difference with the extruder driver anyway which tries to move but is super weak and can't.

Viewing all articles
Browse latest Browse all 2228

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>