Re: Motors wont turn same old same old

Quote
tyscof
When I wired my motors I checked to see what what two wires had the most resistance on them and cut the center tap, on the motors the wires are all blue except for the two center taps which are orange, so i cut those off. I then put the two wires next too each other in a 4 prong connector. I wired it so that the outer wire on the motor connector is the outer wire on the 4 pin connector.
PIN1= B-
COMMON
PIN3= B
PIN4= A
COMMON
PIN6= A-

So right now I have it wired that B- will be the outer most wire B+ and A+ are the inner wires with A- on the outside aswell. Is this wrong?