The label current value is not a "requirement". Its rather a maximum current, e.g. from the coil wire diameter and perhaps something from the motor's magnetics. So the actual driver setting has to be lower than label current, thats the point, not the other way around.
So for example if a motor is labeled 1.2v and 2.4A, that is quite good to run at 12v and 1A driver setting. IMO, much better than 1A label running 1A setting.
So for example if a motor is labeled 1.2v and 2.4A, that is quite good to run at 12v and 1A driver setting. IMO, much better than 1A label running 1A setting.