Quantcast
Channel: Reprap Forum - Stepper Motors, Servo Motors, DC Motors
Viewing all articles
Browse latest Browse all 2228

Re: Stepper selection - voltage confusion.

$
0
0
You only need to have a motor that runs at printer speeds. Getting a very low voltage motor with a very high current requirement is not a good idea. Motors with 0.5 to 1.0 A currents are out there cheap. Anything much over that is going to make your drivers a lot less happy.

Viewing all articles
Browse latest Browse all 2228

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>