still need images to see how you have set things up
One thing to try is ramps basic test firmware. RAMPS test firmware
This requires zero configuration and moves all steppers and toggles the mosfets. (so remove any heaters)
if steppers move with this test firmware, your issue its a firmware issue. If they don't, you have a hardware issue.
Other things to check.
You should have 3 jumper under each stepper drivers to set the micro stepping to 1/16.
You need external 12v on the 5amp ramps plug for the steppers to move. (12v 11amp plug is only for heated bed)
One thing to try is ramps basic test firmware. RAMPS test firmware
This requires zero configuration and moves all steppers and toggles the mosfets. (so remove any heaters)
if steppers move with this test firmware, your issue its a firmware issue. If they don't, you have a hardware issue.
Other things to check.
You should have 3 jumper under each stepper drivers to set the micro stepping to 1/16.
You need external 12v on the 5amp ramps plug for the steppers to move. (12v 11amp plug is only for heated bed)