I bought the printer back in 2013 and that's just how it was built. I changed and replaced a lot over the years but didn't change the overall structure of the x axis itself (only a new motor, new belt/pulleys and new hotend carrier so far).
The motor is a 1.7A Nema 17 stepper from Wantai with 0.9°/step and 4kg/cm torque. I tried currents from 0.8A to 1.6A but the step losses persisted.
The motor is a 1.7A Nema 17 stepper from Wantai with 0.9°/step and 4kg/cm torque. I tried currents from 0.8A to 1.6A but the step losses persisted.