The stepper drivers used can only drive 4 or 6 wire steppers.
4 wires you just identify the coils and plug them in
5 wires you would need to cut the joining center taps (inside the motor) ,
6 wires you ignore the com connections an treat it like a 4 wire.
8 wires you would need to turn it into 4 wires.
4 wires you just identify the coils and plug them in
5 wires you would need to cut the joining center taps (inside the motor) ,
6 wires you ignore the com connections an treat it like a 4 wire.
8 wires you would need to turn it into 4 wires.