Reducing the current was my first thought too and I have dialled it back a bit on both drivers but it still seems the same. I didn't want to go too far down that route in case I went too far on one side and it started losing steps, they were out of sync and skipping steps when I first got it & I'm sure it caused some minor psychological damage trying to figure out what was happening.
I'm not sure if this board (MKS Base V1.4) can be put into a sleep mode for drivers but I'll look into it. The firmware is a cut down tailored piece of work (quite well done though) , everything seems to be dumped into the configuration.h and configuration_adv.h. It's a slick setup but not so user friendly in some respects.
I'll dig my way through it Tomorrow and see what I can find.
Thanks for the reply @VDX
I'm not sure if this board (MKS Base V1.4) can be put into a sleep mode for drivers but I'll look into it. The firmware is a cut down tailored piece of work (quite well done though) , everything seems to be dumped into the configuration.h and configuration_adv.h. It's a slick setup but not so user friendly in some respects.
I'll dig my way through it Tomorrow and see what I can find.
Thanks for the reply @VDX