It is not binding!!!!!!!!!
It has been completely rebuilt Brand New Bearings, Smooth rods cleaned and adjusted for the smoothest possible travel.
I have now replaced the Y-Axis stepper motor twice still layer shifting. Re-flashed the Firmware back to a known good Marlin 1.1.5 and then back to Marlin 1.1.9
Reapplied Aluminum foil Duct tape used for shielding the LCD / SD card cables from EFI / Stepper motor noise.
Carefully testing both firmware's have the same layer shifting, the only thing that has not been tested is the new power supply for noise.
Hold it! Why do I not have the New power supply on the 3D Printer and only this small 24 volt 360watt 15A supply.
I remember now the brand new S-500-24 power supply arrived dead and had to get a replacement so threw on this cheep supply for testing when supply died.
Will replace the Supply and Get back!
Forgot have not tried to replace the Drive Belt.
It has been completely rebuilt Brand New Bearings, Smooth rods cleaned and adjusted for the smoothest possible travel.
I have now replaced the Y-Axis stepper motor twice still layer shifting. Re-flashed the Firmware back to a known good Marlin 1.1.5 and then back to Marlin 1.1.9
Reapplied Aluminum foil Duct tape used for shielding the LCD / SD card cables from EFI / Stepper motor noise.
Carefully testing both firmware's have the same layer shifting, the only thing that has not been tested is the new power supply for noise.
Hold it! Why do I not have the New power supply on the 3D Printer and only this small 24 volt 360watt 15A supply.
I remember now the brand new S-500-24 power supply arrived dead and had to get a replacement so threw on this cheep supply for testing when supply died.
Will replace the Supply and Get back!
Forgot have not tried to replace the Drive Belt.