Thank You!
Still learning.
I have checked the Y-Axis belt and drive belt pulley for debris
I have Replaced all bearings on the Y axis Cleaned and lubricated Lead-Screws and Smooth-rods.
I Replaced the Y-Axis Stepper.
I Replaced the Controller with a backup controller.
I have re-adjusted the V-Ref constant current. Will drop it back down it was only for this test.
Nothing is binding. With power off you can easily push the X,Y Axis without any friction.
Beginning to think I'm Chasing a Ghost, printed the CD Card holder using Octoprint over USB and LCD SD Card images.
I printed Other Models A large Pop Bottle Bird Feeder, Y Axis Belt Holder and neither have layer Shifting.
May just forget about it and keep printing an see if it shows up with other models later on.
Still learning.
I have checked the Y-Axis belt and drive belt pulley for debris
I have Replaced all bearings on the Y axis Cleaned and lubricated Lead-Screws and Smooth-rods.
I Replaced the Y-Axis Stepper.
I Replaced the Controller with a backup controller.
I have re-adjusted the V-Ref constant current. Will drop it back down it was only for this test.
Nothing is binding. With power off you can easily push the X,Y Axis without any friction.
Beginning to think I'm Chasing a Ghost, printed the CD Card holder using Octoprint over USB and LCD SD Card images.
I printed Other Models A large Pop Bottle Bird Feeder, Y Axis Belt Holder and neither have layer Shifting.
May just forget about it and keep printing an see if it shows up with other models later on.