Quote
forreason
in the datasheet here the ratingsBipolar Setup are 5.61 V @ 0.85 A. Which would mean I have to drive it with 22-24V @ 0.85 A from the datasheet?
yes.
Quote
forreason
another Question that I have:
Some of the Steppers I got are Unipolar. Which should result in less torque at lower speeds but higher torque for higher speeds. Can I as well just hook up a unipolar stepper driver?
Some unipolar stepper motors have the center taps of each coil joined.. you can't use these with standard stepper drivers. (unless you modify the stepper motor)
If they are not joined, they work fine.