The A4982SLPT like its predecessor the A4988 are constant current devices.
Does this mean that If I upgrade the Supply Power Supply from 12 to 24 VDC that I will not have to readjust the V-Ref voltage and they should be OK!
This would also mean that If I take a spare stepper from my 3DP11 : 12vdc printer.
Then there should be no problems connecting it to the 3DP12 : 24VDC printer.
If I adjust the same the stepper V-Ref adjustable current limiting that is was using on the 12V - 3D Printer.
Does this mean that If I upgrade the Supply Power Supply from 12 to 24 VDC that I will not have to readjust the V-Ref voltage and they should be OK!
This would also mean that If I take a spare stepper from my 3DP11 : 12vdc printer.
Then there should be no problems connecting it to the 3DP12 : 24VDC printer.
If I adjust the same the stepper V-Ref adjustable current limiting that is was using on the 12V - 3D Printer.