I’m using tmc 2130 with SPI interface in my kossel build the motors have 2.0A peak. I’m using 12v in my power supply. That driver are winey at 12v its goes very hot. I read that is good for a low-current motors.
With that said I'm looking for a good driver, (good resolution, silent). I've found SD6128 that uses the chip THB6128. However I'm not seeing the configuration for that drive/chip in marlin 1.1.9. So I'm investigate how to connect this driver using marlin.
Could anyone give some help were? There is any other good drive for my spefications?
With that said I'm looking for a good driver, (good resolution, silent). I've found SD6128 that uses the chip THB6128. However I'm not seeing the configuration for that drive/chip in marlin 1.1.9. So I'm investigate how to connect this driver using marlin.
Could anyone give some help were? There is any other good drive for my spefications?