So, i am aware that it has been posted thousands of times by now, but no matter what i try, i can't seem to get my TMC2130's to work. I am starting with a brand new MKS Gen 1.4 and steppers that are SPI enabled, i am using 5 of them, the one on the E1 is being used an a second Z axis. I am trying to set up Marlin 1.1.9 but i can't seem to get it to work, i get a short to ground on the Y axis as well as all the steppers read as 0:8:00:00:00 except the Y which reads FFF:FFF:FFF or whatever....Not sure what to do or where to go from here. I am using the standard pin configuration online, am i supposed to set those pins in the Marlin firmware somehow? I am about to create a new harness for the steppers so once i am done with that, i will post a pronterface debug to see if that resolved any issues.
↧
