So I had a go again last night.
Printed the cube again but this time it printed all the way. Print looked bad so I then calibrated the esteps.
Went to print the cube again and it froze again at about layer 4/5
I quickly checked all the steppers and they were cold. Motors didn't seem hot either. Tried moving the z up and down via touch screen and it didn't do anything. Tried a pause which moves the extruder to a safe place and nothing. After about 5 mins I pressed stop and extruder move back to 0,0.
My LCD is a MKS TFT32 which I believe is 12v?
Printed the cube again but this time it printed all the way. Print looked bad so I then calibrated the esteps.
Went to print the cube again and it froze again at about layer 4/5
I quickly checked all the steppers and they were cold. Motors didn't seem hot either. Tried moving the z up and down via touch screen and it didn't do anything. Tried a pause which moves the extruder to a safe place and nothing. After about 5 mins I pressed stop and extruder move back to 0,0.
My LCD is a MKS TFT32 which I believe is 12v?