Quote
o_lampe
Are you mixing up TMC2100 and TMC2130 infos? AFAIK the 2130 is configured by SPI and the 2100 relies on cfg pin config.
I'm fairly sure the TMC 2130 is able to be set this way. The datasheet and schematic seem to point towards this being possible.
The v1.0 Fysetc driver has the SPI 'bridge' closed with a blob of solder which according to the docs would appear to suggest it's already in standalone, I'm just wondering whether I need to cut the pins and whether keeping/removing the jumpers on the RAMPS board has any influence on selecting Stealthchop mode.
Sorry if these are silly questions, it's all very new to me still!
