Quantcast
Viewing all articles
Browse latest Browse all 2228

Fysetc TMC 2130 v1.0 in standalone/stealthchop mode on RAMPS 1.4?

Hi all,

Just a simple question really.

I've built my 3D printer with A4988 drivers on a RAMPS 1.4 board but would like to make my X and Y axes a little quieter, so I spotted some v1.0 Fysetc TMC 2130 drivers on a well known auction site and bought them. I've read and re-read Instructables, tutorials and datasheets and am struggling to comprehend what it is I need to do to get these working in Stealthchop mode.

Some posts and tutorials say remove all the jumpers (MS1 --> MS3) on the RAMPS, others say leave them in.

Looking at the datasheet, it says CFG1 and CFG2 need to be open for 1/16 Stealthchop, so would I be right in thinking I should just cut the SDI (CFG1) and SCK (CFG2) pins from the driver and I'm done? I guess if I cut the pins, then the jumper positions make no difference?

Cheers

Joe

Viewing all articles
Browse latest Browse all 2228

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>