Oh no. This is really embarrassing!
Yes I had set it to half-steps instead of 1/16. I discovered it because my big boy was disappointed that it was not moving yet. When I put all the belts on, I could see that when I moved it 10 mm in octoprint it moved significantly longer. Actually exactly 8 times longer. :)
The reference image I used to set the jumpers from was up side down compared to my RAMPS. This was probably something an experienced builder would catch immediately. I could clearly hear a difference in motor noise after I set the jumper correctly.
However, I have learned more about the speed of stepper motors, and I am grateful for that. Thanks :)
Yes I had set it to half-steps instead of 1/16. I discovered it because my big boy was disappointed that it was not moving yet. When I put all the belts on, I could see that when I moved it 10 mm in octoprint it moved significantly longer. Actually exactly 8 times longer. :)
The reference image I used to set the jumpers from was up side down compared to my RAMPS. This was probably something an experienced builder would catch immediately. I could clearly hear a difference in motor noise after I set the jumper correctly.
However, I have learned more about the speed of stepper motors, and I am grateful for that. Thanks :)
