jkoljo Wrote:
-------------------------------------------------------
> But to be realistic, you will not hit the
> microcontroller speed limit with 0.9 steppers and
> 16x microstepping.
>
> I am using 0.9 degree motors, and I am very happy
> with them. More accurate printing.
Can you kindly tell me the configuration changes you had to make? I've been told to increase (double) the steps/mm value, but not quite sure where that setting is. Also, are there any other places I would need to make changes?
I'm using Marlin firmware on RAMPS 1.4 by the way.
Thank you.
-------------------------------------------------------
> But to be realistic, you will not hit the
> microcontroller speed limit with 0.9 steppers and
> 16x microstepping.
>
> I am using 0.9 degree motors, and I am very happy
> with them. More accurate printing.
Can you kindly tell me the configuration changes you had to make? I've been told to increase (double) the steps/mm value, but not quite sure where that setting is. Also, are there any other places I would need to make changes?
I'm using Marlin firmware on RAMPS 1.4 by the way.
Thank you.