I have yet to print anything so I am not really sure how it will sound. I am testing by jogging the z axis up and down and comparing this to x and y axis. It will be loud on certain steps but quiet on others. But in general sounds much louder.
My conclusion is to just swap out the z axis stepper motor since it is different from the others...
Support from Watterott suggested Stealthchop mode and refining the current but I am hesitant to do Stealth Chop mode since all reviews mention it is not suitable for 3d printing. I changed the current but it really didn't fix the issue.
My conclusion is to just swap out the z axis stepper motor since it is different from the others...
Support from Watterott suggested Stealthchop mode and refining the current but I am hesitant to do Stealth Chop mode since all reviews mention it is not suitable for 3d printing. I changed the current but it really didn't fix the issue.