Sorry missed your post. Either Way I bought the drivers and installed them for X, Y and Z for now. I have yet to print anything ..will do this soon and post updates. I am using the drivers in spreadcycle mode since most recommended that mode to reduce chance of missed steps.
They are probably 1/3 the noise of the stock drivers. It has a small hiss to them but no where near the deeper sounds that come off regular drivers. It is slightly louder than the fan...
My new issue is that I am finding the Z axis is much louder. It's is very hissy while idle and has variable noise while moving up and down (still less noise than the regular drivers). Is this because the Z axis motor is different from the x and y? I am not sure why the Z axis would be any different from the rest since the motor specs appear to be very similar. I played with the pots but nothing seem to fix it...
They are probably 1/3 the noise of the stock drivers. It has a small hiss to them but no where near the deeper sounds that come off regular drivers. It is slightly louder than the fan...
My new issue is that I am finding the Z axis is much louder. It's is very hissy while idle and has variable noise while moving up and down (still less noise than the regular drivers). Is this because the Z axis motor is different from the x and y? I am not sure why the Z axis would be any different from the rest since the motor specs appear to be very similar. I played with the pots but nothing seem to fix it...