I'm using an MKS Gen 1.4 which is basically RAMPS/Arduino together.
So I would remove all the jumpers underneath the stepper driver socket headers and then bridge CFG1 pads, and bridge CFG1 to GND just in case and it should be 16/256 in spreadCycle.... right?
I bought a 600x USB microscope, so when they arrive, I can take photos as well.
So I would remove all the jumpers underneath the stepper driver socket headers and then bridge CFG1 pads, and bridge CFG1 to GND just in case and it should be 16/256 in spreadCycle.... right?
I bought a 600x USB microscope, so when they arrive, I can take photos as well.