Quote
Wurstnase
If you buying a TMC2100 from MKS you must solder the small pad.
When you don't solder that small pad
[attachment 85591 addon.jpg]
the pin has no connection to the chip. So your soldered bridge from GND to that pin does nothing.
so does bridging the missing connection complete the spreadCycle mode configuration, or does one still need to jump CFG1 to GND in conjunction with the missing bridge?
lets recap:
do both CFG1 the CFG6 pad pairings on the bottom of the board need to be bridged?
does the CFG1 to GND bridge on the top need to be done as well afterwards?
these are the ones i ordered (shown below).
they seem to have CFG1 pads bridged. so now I just connect GND to CFG1 on the top side?
