Yes I am actually looking for some new drivers. I want the 1/128 Pololu's so right now I am shopping around for the right 32 bit controller to control them. What controller will dc 42 recommend? Is it the re-arm controller? Because I looked it up and it looked good but I couldn't find where to buy it. I am going to keep reading up on different controllers so I don't get something and regret it. I just want a little more performance so I don't plan on spending too much.
BTW I guess I have been poking around in configuration h. too much. I started to think about what could cause the sputtering while watching it print and I realized I must have turned down the jerk setting too low and my motors were getting limited by the controller everytime they tried to accelerate. I turned it back up to 10 and it is running very smooth again. I have been doing some upgrades all day so now I can finally enjoy them.
BTW I guess I have been poking around in configuration h. too much. I started to think about what could cause the sputtering while watching it print and I realized I must have turned down the jerk setting too low and my motors were getting limited by the controller everytime they tried to accelerate. I turned it back up to 10 and it is running very smooth again. I have been doing some upgrades all day so now I can finally enjoy them.