Once again
I am doing a project ---- here is no information but
I can't wire and know nothing --- please design and do project for me!!
:X
It would be nice to know what your stepper is going to do?
Does it need a lot of power, high current?
What CNC shield?
The supplier of shield doesn't help at all?
Are you going to use a special firmware / software to run project?
GRBL --- is nice and simple
You could use an Arduino and an Easy Driver powered by 6 to 30V power supply?
Power arduino via USB and power motor, via driver,
with any 12 - 24 volt supply that delivers 2+ amps
[learn.sparkfun.com]
:S
I am doing a project ---- here is no information but
I can't wire and know nothing --- please design and do project for me!!
:X
It would be nice to know what your stepper is going to do?
Does it need a lot of power, high current?
What CNC shield?
The supplier of shield doesn't help at all?
Are you going to use a special firmware / software to run project?
GRBL --- is nice and simple
You could use an Arduino and an Easy Driver powered by 6 to 30V power supply?
Power arduino via USB and power motor, via driver,
with any 12 - 24 volt supply that delivers 2+ amps
[learn.sparkfun.com]
:S