Thank you very much! :)
I'm just in the beginning of my project so I haven't chosen any parts yet - better get parts that are compatible with each other. ;) I've already thought to use a 24V power so it seems I'm on the right track... (Those are widely used at least in 2d-printers so there must be some reason for that, right? :D) I was too a bit skeptical about my first suggestion because the inductance seemed very high compared to many steppers used in 3d-printers and, if I'm not wrong, high inductance means lots of heat and slower reactions = not good. Anyway, I'm glad to hear that the second option seems good. :) I'll probably buy those. :) I was thinking to use Smoothieboard because many people seem to recommend it and it seems like a very capable board, got to check the Duet (WiFi) also...
Great! Now my 3d-printer is not far from finished. :D Anyway, I have a further question: would this be a good choice for the z-axis? Would it work well with Smoothie/Duet? I would also appreciate some recommendations for the extruder stepper (I'll be using bowden extruder with 1.75mm filament). Thanks again! :)
I'm just in the beginning of my project so I haven't chosen any parts yet - better get parts that are compatible with each other. ;) I've already thought to use a 24V power so it seems I'm on the right track... (Those are widely used at least in 2d-printers so there must be some reason for that, right? :D) I was too a bit skeptical about my first suggestion because the inductance seemed very high compared to many steppers used in 3d-printers and, if I'm not wrong, high inductance means lots of heat and slower reactions = not good. Anyway, I'm glad to hear that the second option seems good. :) I'll probably buy those. :) I was thinking to use Smoothieboard because many people seem to recommend it and it seems like a very capable board, got to check the Duet (WiFi) also...
Great! Now my 3d-printer is not far from finished. :D Anyway, I have a further question: would this be a good choice for the z-axis? Would it work well with Smoothie/Duet? I would also appreciate some recommendations for the extruder stepper (I'll be using bowden extruder with 1.75mm filament). Thanks again! :)