The ending g4vs is a customer kode. I.e for special axel, gear and so on. I know this because i work with copy machines and they use alot off the same motors but with different gears on. :-)
So don't think about the g4vs.
If you look here u see that your motor is a 400nNm in unipolar setup and 500nNm in bipolar. (they should be hybrid motors as all others) :-)
[www.eminebea.com]
Some fine motors
Jesper
So don't think about the g4vs.
If you look here u see that your motor is a 400nNm in unipolar setup and 500nNm in bipolar. (they should be hybrid motors as all others) :-)
[www.eminebea.com]
Some fine motors
Jesper