Hi
I have access to many parts from old Laser Printers with Scanners and would like to build a DIY 3D Printer.
The mechanical part is clear and easy but I need help with the Stepper Motors.
I have two different:
1st
MINEBEA
Type 17PM-K018-G22ST
17 -Motor Size
P -Type of Motor (42mm)
M -Step Angle (1.8 deg)
K -Type of Laminated Stator (2 Phase Hybrid (Low Noise, Low Vibration)
0 -Motor Length at Right (34mm)
18 -Electrical Variation
2nd
SHINANO KENSHI STP-42D204-01
3.15 V
0.7 Amp
4.5 Ohms/phase
1.8 deg/step
Those are all the information I could find, both have four cables.
Does anyone have deeper knowledge and can tell me if they can be made working with a RAMPs or other Controlboard?
I have access to many parts from old Laser Printers with Scanners and would like to build a DIY 3D Printer.
The mechanical part is clear and easy but I need help with the Stepper Motors.
I have two different:
1st
MINEBEA
Type 17PM-K018-G22ST
17 -Motor Size
P -Type of Motor (42mm)
M -Step Angle (1.8 deg)
K -Type of Laminated Stator (2 Phase Hybrid (Low Noise, Low Vibration)
0 -Motor Length at Right (34mm)
18 -Electrical Variation
2nd
SHINANO KENSHI STP-42D204-01
3.15 V
0.7 Amp
4.5 Ohms/phase
1.8 deg/step
Those are all the information I could find, both have four cables.
Does anyone have deeper knowledge and can tell me if they can be made working with a RAMPs or other Controlboard?