Re: Test Code Not Working

Here is the log when connected from Repetier.

21:36:38.156 : echo:Marlin 1.1.0-RC3
21:36:38.156 : echo: Last Updated: 2015-12-01 12:00 | Author: (none, default config)
21:36:38.156 : Compiled: Dec 26 2015
21:36:38.156 : echo: Free Memory: 4322 PlannerBufferBytes: 1232
21:36:38.160 : echo:Hardcoded Default Settings Loaded
21:36:38.160 : echo: Steps per unit:
21:36:38.160 : echo: M92 X80.00 Y80.00 Z4000.00 E500.00
21:36:38.164 : echo:Maximum feedrates (mm/s):
21:36:38.164 : echo: M203 X300.00 Y300.00 Z5.00 E25.00
21:36:38.168 : echo:Maximum Acceleration (mm/s2):
21:36:38.169 : echo: M201 X3000 Y3000 Z100 E10000
21:36:38.173 : echo:Accelerations: P=printing, R=retract and T=travel
21:36:38.173 : echo: M204 P3000.00 R3000.00 T3000.00
21:36:38.181 : echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
21:36:38.181 : echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00
21:36:38.185 : echo:Home offset (mm):
21:36:38.185 : echo: M206 X0.00 Y0.00 Z0.00
21:36:38.185 : echo:Material heatup parameters:
21:36:38.185 : echo: M145 M0 H180 B70 F0
21:36:38.189 : echo: M145 M1 H240 B110 F0
21:36:38.189 : echo: PID settings:
21:36:38.193 : echo: M301 P22.20 I1.08 D114.00 C100.00 L20
21:36:38.193 : echo:Filament settings: Disabled
21:36:38.193 : echo: M200 D3.00
21:36:38.193 : echo: M200 D0
21:36:39.788 : FIRMWARE_NAME:Marlin 1.1.0-RC3 From Archive SOURCE_CODE_URL:http:// ... PROTOCOL_VERSION:1.0 MACHINE_TYPE:3D Printer EXTRUDER_COUNT:1 UUID:00000000-0000-0000-0000-000000000000
21:36:39.809 : X:0.00 Y:0.00 Z:0.00 E:0.00 Count X: 0.00 Y:0.00 Z:0.00
21:36:39.810 : echo:Active Extruder: 0
21:36:39.880 : echo:Active Extruder: 0
21:36:55.807 : Reporting endstop status
21:36:55.807 : x_min: open
21:36:55.807 : x_max: open
21:36:55.807 : y_min: open
21:36:55.807 : y_max: open
21:36:55.807 : z_min: open
21:36:55.807 : z_max: open