Quote
Wurstnase
Quote
Dust
Ok, so I changed my drivers, they were in the wrong position. Wired 1 stepper motor and ran the RAMPS test code and the motor start moving with some noise and small vibrations. Then I stopped the power, and plugged in 4 drivers and 3 motors, and ran the test again to see if all the motor are moving. All of them start moving with the same noise and vibration, but they were moving !, so that's a good start.
What I've noticed. After only 30 seconds of test, all drivers were extremely hot and the glue underneath I think started to smell. I turned it off, and removed all drivers and kept only 2 with 1 stepper motor.
Ran the test again, this time uploading the Marlin firmware and connecting to Pronterface...all good, moved the X axis..it waits for 1-2 seconds and then it moves nice, without the same noise and vibration like in the ramps test.
I measured the voltage on drivers, they all show 1.6 V when I have the stepper in.
Now I need to find out why are the drivers getting so fast very hot ...