Hi,
Yes, there is only one motor in because I wanted to test them each separately, but I tried 3 at once as well.
The wiring from the steppers I took is from ramps 1.4 wiring diagram, being with the blue cable in front of the power line, also tested each wire to check the pairs, so first pair (blue-red) goes to 2B-2A, and second pair (red-black) goes to 1A-1B. I tried to put the 4 wires the other side around, with the black in front of power line, just to see if it moves, but still nothing.
I remember I tried moving the motor by hand slowly while it's powered on, and I believe I was able to move it.
I didn't measured the voltage on the motors, just the ohms.
And something else I remembered now, I tested last night with all the drivers in (4) and 3 stepper motors..the ramps and the LCD didn't turned on, but after I removed 2 drivers and 1 stepper, the ramps and arduino worked fine :/. Maybe when I fried my Arduino voltage regulator, one of the drivers died as well. How should I check each driver if they are still good, or what was the problem causing the board not to turn on ?
Thank you very much !
Yes, there is only one motor in because I wanted to test them each separately, but I tried 3 at once as well.
The wiring from the steppers I took is from ramps 1.4 wiring diagram, being with the blue cable in front of the power line, also tested each wire to check the pairs, so first pair (blue-red) goes to 2B-2A, and second pair (red-black) goes to 1A-1B. I tried to put the 4 wires the other side around, with the black in front of power line, just to see if it moves, but still nothing.
I remember I tried moving the motor by hand slowly while it's powered on, and I believe I was able to move it.
I didn't measured the voltage on the motors, just the ohms.
And something else I remembered now, I tested last night with all the drivers in (4) and 3 stepper motors..the ramps and the LCD didn't turned on, but after I removed 2 drivers and 1 stepper, the ramps and arduino worked fine :/. Maybe when I fried my Arduino voltage regulator, one of the drivers died as well. How should I check each driver if they are still good, or what was the problem causing the board not to turn on ?
Thank you very much !